Product type designation | RUGGEDCOM RS400NC |
Product description | serial device server with an integrated fully managed Ethernet switch, 56-bit Encryption, 4 port serial server, 4 port managed Ethernet switch & an optional V.90 modem |
| The RUGGEDCOM RS400NC is an industrially hardened, serial device server with an integrated, fully managed, Ethernet switch, designed to operate reliably in electrically harsh and climatically demanding environments. 56-bit Encryption; 4 port serial server, 4 port managed Ethernet switch & an optional V.90 modem |
Transmission rate |
Transfer rate | 10 Mbit/s, 100 Mbit/s |
acc. to RS 232 | 300 bit/s ... 115200 bit/s |
acc. to RS 422/485 | 300 bit/s ... 115200 bit/s |
acc. to V.90 | 56000 bit/s |
Interfaces |
Number of electrical/optical connections | |
for network components or terminal equipment / maximum | 4 |
Number of electrical connections | |
for network components or terminal equipment | 4 |
for network components or terminal equipment / maximum | 4 |
for serial interfaces / acc. to RS 232/RS 422/RS 485 / maximum | 4 |
for modem / maximum | 1 |
for signaling contact | 1 |
for power supply | 1 |
for redundant voltage supply | 0 |
Type of electrical connection | |
for network components or terminal equipment | RJ45-Port, SUB-D 9 pin |
for signaling contact | 3-pole terminal block |
for power supply | 3-pole terminal block |
Number of optical interfaces | |
for network components or terminal equipment / maximum | 2 |
for fiber optic cable / at 10 Mbit/s | 4 |
for fiber optic cable / at 100 Mbit/s | 4 |
Design of the optical interface / for fiber optic cable | |
at 10 Mbit/s | ST-Port (BFOC-Port) |
at 100 Mbit/s | ST-/SC-/MTRJ-/LC-Port |
Range | |
at the optical interface / depending on the optical fiber used / minimum | 2 km |
at the optical interface / depending on the optical fiber used / maximum | 90 km |
Insulation voltage / for serial interfaces / acc. to RS 232/RS 422/RS 485 / rated value | 2 kV |
Signal-Inputs/outputs |
Relay design | Form-C contact relay |
Operating voltage / of the signaling contacts | |
at AC / Rated value | 30 V |
at AC / maximum | 250 V |
at DC / Rated value | 30 V |
at DC / maximum | 80 V |
Operating current / of the signaling contacts | |
at AC / maximum | 0.6 A |
at AC / at 250 V / maximum | 0.2 A |
at DC / maximum | 1 A |
at DC / at 30 V / maximum | 1 A |
Supply voltage, current consumption, power loss |
Product options / wide range power supply | Yes |
Supply voltage / 1 / Rated value | 24 V |
Supply voltage / 1 / rated value | 10 ... 36 V |
Type of voltage / 1 / of the supply voltage | DC |
Supply voltage / 2 / Rated value | 48 V |
Supply voltage / 2 / rated value | 36 ... 59 V |
Type of voltage / 2 / of the supply voltage | DC |
Supply voltage / 3 / Rated value | 110 V |
Supply voltage / 3 / rated value | 88 ... 300 V |
Type of voltage / 3 / of the supply voltage | DC |
Supply voltage / 4 / Rated value | |
Supply voltage / 4 / rated value | 85 ... 265 V |
Type of voltage / 4 / of the supply voltage | AC |
Product component / fusing at power supply input | Yes |
Power loss [W] | |
maximum | 8 W |
Permitted ambient conditions |
Ambient temperature | |
during operation | -40 ... +85 °C |
during storage | -40 ... +85 °C |
during transport | -40 ... +85 °C |
Note | A maximum operating temperature of +85 °C is permissible for a duration of 16 hours |
Relative humidity / at 25 °C / without condensation / during operation / maximum | 95 % |
Operating condition / fanless operation | Yes |
Protection class IP | IP40 |
Design, dimensions and weight |
Design | compact |
Width | 202 mm |
Height | 44 mm |
Depth | 291 mm |
Net weight | 2.2 kg |
Product feature / conformal coating | optional |
Material / of the enclosure | 18 AWG galvanized steel enclosure |
Mounting type | |
35 mm DIN rail mounting | Yes |
S7-300 rail mounting | No |
19-inch installation | Yes |
wall mounting | Yes |
Product properties, functions, components / general |
Product component / Integrated / Ethernet switch | Yes |
Product function | |
DNP 3.0 to DNP conversion via UDP/TCP | Yes |
Modbus RTU to Modbus TCP conversion | Yes |
RAW socket mode for any serial protocols | Yes |
Protocol / is supported | |
DNP3 | Yes |
GVRP | Yes |
HTTP | Yes |
Modbus TCP | Yes |
TFTP | Yes |
Number of automatically learnable MAC addresses | 2048 |
Number of priority channels | 4 |
Operating mode | |
multi-point | Yes |
Point-to-point | Yes |
Product function / port-rate-limiting | Yes |
Product feature | |
Store & Forward switching method | Yes |
Product function | |
support several modbus masters | Yes |
Protocol / is supported | |
PPP | Yes |
TIN | Yes |
Storage capacity | |
of the MAC-address table | 16 Kibyte |
of message buffer / maximum | 1 Mibyte |
Switch latency period | 5 µs |
Transfer rate / of the switch | 1.2 Gbit/s |
Product functions / management, configuration |
Product function | |
CLI | Yes |
RMON | Yes |
web-based management | Yes |
Protocol / is supported / Telnet | Yes |
Product functions / Diagnosis |
Protocol / is supported | |
SNMP v1 | Yes |
SNMP v2c | Yes |
SNMP v3 | Yes |
Product function | |
MIB support | Yes |
for MIB support | |
— by BRIDGE-MIB | RFC1493 |
— by IF-MIB | RFC2863 |
— by RMON-MIB | RFC2819 |
— by RSTP-MIB | draft-ietf-bridge-bridgemib-smiv2-03 |
— by SNMPv2-MIB | RFC1907 |
— by SNMPv2-SMI | RFC2578 |
— by SNMPv2-TC | RFC2579 |
— by TCP-MIB | RFC2012 |
— by UDP-MIB | RFC2013 |
Product functions / VLAN |
Number of VLANs / maximum | 15 |
Product function / VLAN - port based | Yes |
VLAN identification number | 1 ... 1000 |
Product functions / DHCP |
Product function | |
DHCP Option 82 | No |
Product functions / Redundancy |
Product function | |
redundancy procedure MSTP | No |
redundancy procedure RSTP | Yes |
eRSTP | Yes |
Protocol / is supported | |
MSTP | No |
RSTP | Yes |
Product functions / Security |
Product function | |
IEEE 802.1x (radius) | No |
RADIUS client | Yes |
Protocol / is supported | |
SSL | Yes |
RADIUS | Yes |
TACACS+ | Yes |
Key length | |
with SSL | 56 bit |
with RSA | 1024 bit |
Product functions / Time |
Protocol / is supported | |
NTP | No |
SNTP | Yes |
Standards, specifications, approvals |
Standard | |
for EMC | FCC Part 15 (Class A), EN55022 (CISPR22 Class A) |
for safety / from CSA and UL | UL 60950-1, CSA C22.2 no. 60950-7 |
for hazardous zone / from CSA and UL | Hazardous Locations: Class 1 Division 2 |
for emitted interference | EN 61000-6-4 (Class A) |
for interference immunity | EN 61000-6-2 |
Laser protection class | Complies with 21 CFR Chapter 1, Subchapter J |
Certificate of suitability | EN 61000-6-2, EN 61000-6-10 |
relating to NEMA | TS 2 |
CE marking | Yes |
C-Tick | No |
IEC 61850-3 | Yes |
IEEE 1613 | Yes |
according to FIPS 140-2 | No |
according to Common Criteria (CC) | No |
Product conformity | |
acc. to IEEE 802.3-10BaseT | Yes |
acc. to IEEE 802.3u-100BaseTX | Yes |
acc. to IEEE 802.1Q-2005 (formerly IEEE 802.1s) MSTP | No |
acc. to IEEE 802.1x-port based Network Access Control | No |
acc. to IEEE 802.3u-100BaseFX | Yes |
acc. to IEEE 802.3x-Flow Control | Yes |
acc. to IEEE 802.3ad-Link Aggregation | No |
acc. to IEEE 802.1d-MAC Bridges | Yes |
acc. to IEEE 802.1d-STP | Yes |
acc. to IEEE 802.1p-class of service | Yes |
acc. to IEEE 802.1Q-VLAN tagging | Yes |
acc. to IEEE 802.1w-RRST | Yes |
RFC768-UDP | Yes |
RFC783-TFTP | Yes |
RFC791-IP | Yes |
RFC792-ICMP | Yes |
RFC793-TCP | Yes |
RFC826-ARP | Yes |
RFC854-Telnet | Yes |
RFC894-IP over Ethernet | Yes |
RFC1112-IGMPv1 | Yes |
RFC1519-CIDR | Yes |
RFC2030-SNTP | Yes |
RFC2068-HTTP | Yes |
RFC2236-IGMPv2 | Yes |
RFC1541-DHCP (client) | Yes |
RFC1661-PPP | Yes |
Product function / Transmission of serial data via IP-Networks | Yes |